General topics » Trip Reset

Is there a quick way on the 1250 RS to zero the trip (like push and hold a buttom for 3 seconds) rather than having to go into settings and is there a way to change from MPH to KPH for european trips

If you have a Nav V or VI you can clear it on the Nav screen.

mmmm dont have one of those yet.

This is on my GSA

20200109_154940.jpg - Bild entfernt (keine Rechte)

Notice box is checked. This resets every time I refuel.

Cool I'll have a look. Ta.

That’s where mine is set

Apparently, on the R1250RS at least, the Trip Computer only resets after at least six hours have elapsed and the date has changed since the ignition was switched on, if the ‘Reset automatically’ setting it ticked. It doesn’t seem to be tied to re-fuelling.

7AB5CCA6-0521-4A54-8B16-758EE99A8748.png - Bild entfernt (keine Rechte)

You'd have thought BMW would have had a hold this button for x seconds to zero the trip so oncè refueled you knew where you were.

Zitat von Barleymo im Beitrag #8

---

You'd have thought BMW would have had a hold this button for x seconds to zero the trip so oncè refueled you knew where you were.

---

The 1200 has a Trip 1, Trip 2 and Trip A, which is the "daily" automatic trip you're talking about.

Since its a little more complicated of a screen with tons of trip information, you cant just hold a button and clear what you want. However, I have discovered I can go in the screen posted above during each fillup, and clear only certain parameters I want cleared for that trip, but not the entire trip information. My previous Harley you could just hold the trip button for a couple seconds and it would reset the trip mileage. But then again, that was pretty much the extent of the information you got...

yes i think its a large omission on BMW's part

There is a way to reset the tripmeter to show distance after fill up. I use the Nav V, but there is also a way to do it with the TFT. Sorry, I have forgotten how I did it, but it is obvious once you start looking..

Be grand if you can remember.

I’m a bit puzzled by this thread, what’s the difficulty going through the settings to reset the trip - seems easy to me (1200RS) Perhaps this is not so easy on the 1250 version?